FRAM Force™

 If you’re a driver constantly dealing with the challenges of extreme driving conditions,FRAM FORCE™ is the FRAM® oil filter for you. When you need to push your vehicle to the limit, whether from hauling and towing or stop-and-go traffic, you need a filter that offers rugged protection. FRAM FORCE™ is the ideal solution, designed to work with all oil types and up to 15,000 miles (24,000 kilometers) of superior performance.


Advance Auto Parts
Where To Shop


FRAM FORCE™ oil filter is engineered to provide advanced protection for all drivers that experience extreme driving conditions.

Rough non-slip textured surface coats the exterior of the oil filter allowing for easy install and removal.

Precision coil spring with glass-fiber-reinforced nylon poppet provides consistent oil flow even in cold conditions.

Stronger, more durable media provides an outstanding 98%+ dirt-trapping efficiency.*

Synthetic media blend with 20% more pleats increases dirt-trapping and dirt-holding capacity for higher levels of engine protection and longer filter life.

Silicon anti-drainback valve delivers superior start-up engine protection with up to 3X the hot oil resistance.**

Internally lubricated sealing nitrile gasket for easier filter removal.

Exploded-view of FRAM Force oil filter. Designed to work with Dodge Ram, GMC Sierra, GMC Denali and Ford F-150 vehicles.Exploded-view of FRAM Force oil filter. Designed to work with Dodge Ram, GMC Sierra, GMC Denali and Ford F-150 vehicles.

Installation Instructions

  1. Use proper protective gear. Used motor oil should not come in contact with bare skin. Engine oil may be hot.
  2. Place a drain pan under the oil filter and unscrew oil filter.
  3. Clean mounting base, making sure the O-ring from the old filter is not stuck to the filter mount.
  4. Apply film of clean oil to filter gasket. Do not use grease.
  5. Screw new filter on until gasket reaches base contact. Then tighten according to instructions on filter using tightening guide markers.
  6. Check owner’s manual for correct oil specification, viscosity and amount.
  7. Add oil to “full” on dipstick. Idle engine for 5 minutes and check for leaks.
  8. Shut off engine and recheck oil level after 5 minutes and top off as necessary.

Engineered for all oil types and easy to install, FRAM FORCE™ is the engine oil filter for drivers who face demanding driving conditions.

Member of How2Recycle

Related Products

FRAM Titanium Oil FilterFRAM Titanium Oil Filter

FRAM Titanium™
Oil Filter

FRAM Drive Oil FilterFRAM Drive Oil Filter

FRAM Drive™
Oil Filter

FRAM Drive Air FilterFRAM Drive Air Filter

FRAM Drive™
Air Filter

FRAM Drive Cabin Air FilterFRAM Drive Cabin Air Filter

FRAM Drive™
Cabin Filter