Toggle Nav
PARTS SEARCH
  • Compare Products
Menu
Account
Settings
Language
English
Back To Search Results

FRAM Tough Guard® Oil Filter

Add to Compare
SKU
TG9100
More Information
More Information
Where To Shop
Search
  • Description

    FRAM Tough Guard® oil filters are designed for tough driving conditions, stop and go traffic, and hot and cold temperatures. The synthetic blend media is engineered to perform with conventional and synthetic motor oil. Equipped with SureGrip® technology, FRAM Tough Guard oil filters provide a non-slip surface allowing for easy install and removal. The silicone anti-drain back valve ensures safe engine startups, extending the life of the oil filter for up to 15,000 miles (24,000 kilometers).

    • Proven protection for up to 15,000 miles (24,000 kilometers)
    • Engineered for tough driving conditions, stop and go traffic, and hot and cold temperatures
    • SureGrip®?technology for easy install and removal
    • Synthetic blend media provides 99% dirt holding capacity
    • Silicone anti-drain back valve helps ensure safe engine start up

    *FRAM Group testing of average filter efficiency of TG8A, TG3387A and TG4967 under ISO 4548-12 for particles greater than 20 microns.

    **Greater than 3X the functional life of Nitrile ADB when tested per SAE HS806 hot oil and Anti-drain-back test.

    ?Not all features are available on every part number in the product line. Check the package for specific features of individual filters.

  • Applications

    This Item Fits the Following Vehicles:

    Year Make Model Engine
  • Comparison
    COMPETITOR NAME COMPETITOR PART #
  • Installation
    1. Use proper protective gear. Used motor oil should not come in contact with bare skin. Engine oil may be hot.
    2. Place a drain pan under the oil filter and unscrew oil filter.
    3. Clean mounting base making sure the O-ring from the old filter is not stuck to the filter mount.
    4. Apply film of clean oil to filter gasket. Do not use grease.
    5. Screw new filter on until gasket reaches base contact. Then tighten according to instructions on filter using tightening guide markers.
    6. Check owner’s manual for correct oil specification viscosity and amount.
    7. Add oil to “full” on dipstick. Idle engine for 5 minutes and check for leaks.
    8. Shut off engine and recheck oil level after 5 minutes and top off as necessary.