FRAM Synthetic Endurance™ premium oil filters are designed to provide extended durability and performance. Its fully synthetic filtration media delivers 99% filtration efficiency and maximum engine protection for up to 25,000 miles (40,000 kilometers) when paired with the appropriate synthetic or high-mileage motor oil. FRAM Synthetic Endurance™ was specially developed for use in modern vehicles and features heavier steel construction for today's higher flow engines.
Provides maximum protection and performance for up to 25,000 miles (40,000 kilometers).
Optimized for use with synthetic or high mileage oil.
Heavy-duty shell and wire screen back synthetic filter media provides maximum durability.
Designed with a fully synthetic filter media for 99% filtration efficiency.
1 Provides up to 25,000 miles/40,000 km of protection when used with an appropriate synthetic oil. Follow recommended change intervals as outlined in your owner's manual.
*FRAM Group testing of average filter efficiency of FE8A, FE3387A and FE4967 or equivalent FRAM TG or EG models under ISO 4548-12 for particles greater than 20 microns.
**FRAM Group mulitpass testing of representative sampling of average filter capacity of comparable competitive retail products based on ISO4548-12 for FE8A and FE3387A.
***Greater than 3X the functional life of Nitrile ADB when tested per SAE HS806 hot oil and Anti-drain-back test.
+ FRAM Group testing per USCAR-36 Low Temperature Leakage test after hot oil, when compared to standard nitrile gasket.
ꝉ Not all features are available on every part number in the product line. Check the package for specific features of individual filters.
Remove drain plug from housing cap if present and allow oil to drain from cap. Remove housing cap, old gaskets/O-Rings, and filter element. Discard the used filter element and gaskets/O-Rings in the proper manner.
Clean filter housing components and apply a light coating of clean engine oil to the new provided gaskets/O-Rings. Install, being careful to avoid damage to the gaskets/O-Rings. Avoid twisting of the gaskets/O-Rings.
Install new filter element into the housing cap. Reinstall the housing cap and tighten to the proper installation torque as listed on the housing cap or in the service manual. Reinstall the housing cap drain if present to the proper installation torque.