FRAM® Fresh Breeze cabin air filters can keep up to 98% of road dust and pollen particles from entering a vehicle. The only cabin air filter that uses the natural deodorizing properties of ARM & HAMMER™ baking soda. Contaminants that enter the vehicle with outside air through the vehicle’s air conditioning, heating and ventilation system can become concentrated and expose passengers to road dust, dirt and allergens at higher levels than outside the car.
Filters up to 98% of dust, pollen and other contaminants
ARM & HAMMER baking soda combined with carbon embedded in the filter assists in cleaning outside air flowing through the vehicle’s ventilation system
Helps protect your vehicle's heating and air conditioning unit while also keeping it working efficiently
Installs on average in 15 minutes
1. Road dust and pollen particles ranging in size from 5-100 microns. 2. Deodorizing tests used isovaleric acid (sweaty odors), geosmin (earthy odors) and dog hairs. 3. ARM & HAMMER, the ARM & HAMMER logo and distinct orange trade dress are trademarks of Church & Dwight Co., Inc. and used under license by FRAM Group IP LLC. * Always follow OE recommended change intervals.
LOCATION OF CABIN FILTER: On passenger side of the vehicle behind the glove box.
REMOVE ALL DEBRIS IN AND AROUND FILTER LOCATION.
Open the passenger side door. Open the glove box.
Remove the two glove box stops on each side of the glove box by pushing them inward from the backside and pulling them out. If equipped remove the dampener cord located on the right hand side of the glove box.
Allow the glove box to swing down toward the floor board.
Remove the cabin filter assembly by unclipping both sides and pulling it straight out.
Remove the dirty filter from the housing
Install the new cabin filter in the housing.
Install the housing with the new filter in it in the vehicle and make sure it is fully in place and secured.
Partially close the glove box and if you removed a dampener cord earlier re-install it at this time. If you have re-installed
e dampener cord or if you do not have the dampener cord the next step is to re-install the glove box stops on each side of the glove box.