FRAM Fresh Breeze® Cabin Air Filter
| Height (Inch) | 1.576 |
|---|---|
| Width (Inch) | 7.919 |
| Length (Inch) | 8.707 |
Search
- Description
FRAM® Fresh Breeze cabin air filters can keep up to 98% of road dust and pollen particles from entering a vehicle. The only cabin air filter that uses the natural deodorizing properties of ARM & HAMMER™ baking soda. Contaminants that enter the vehicle with outside air through the vehicle’s air conditioning, heating and ventilation system can become concentrated and expose passengers to road dust, dirt and allergens at higher levels than outside the car.
- Filters up to 98% of dust, pollen and other contaminants
- ARM & HAMMER baking soda combined with carbon embedded in the filter assists in cleaning outside air flowing through the vehicle’s ventilation system
- Helps protect your vehicle's heating and air conditioning unit while also keeping it working efficiently
- Installs on average in 15 minutes
1. Road dust and pollen particles ranging in size from 5-100 microns.
2. Deodorizing tests used isovaleric acid (sweaty odors), geosmin (earthy odors) and dog hairs.
3. ARM & HAMMER, the ARM & HAMMER logo and distinct orange trade dress are trademarks of Church & Dwight Co., Inc. and used under license by FRAM Group IP LLC.
* Always follow OE recommended change intervals.
- Applications
This Item Fits the Following Vehicles:
Year Make Model Engine 08-03 SUBARU FORESTER H4-2.5L - Comparison
COMPETITOR NAME COMPETITOR PART # ATP CF-84 Baldwin PA4424 Beck/Arnley 042-2095 Champ CAF1863P Champion CCF1863 Forecast CAF168P FVP F9359 GK Industries CF1150 Hastings AFC1412 Kleener FCAF1863P LUBER-FINER CAF1863P MicroGard 3690 NAPA 9359 Power Train 3690 Premium Guard PC9359 Premium Guard PC5875 Purolator C25875 Service Champ C25875 Subaru G3010-SA100 Subaru 72880-SA000 Valvoline VCA-1114 Warner WCAF1863 Wix 49359 - Installation
TOOLS: Phillips-head Screwdriver.
LOCATION OF CABIN FILTER: On the passenger side of the vehicle behind the glove box.
REMOVE ALL DEBRIS IN AND AROUND FILTER LOCATION.
- While sitting in the passenger seat open the glove box and remove the nine (9) screws which secure the glove box to the dash (three upper screws two lower screws two screws located in the center by the glove box latch one on inside right wall and one on inside left wall).
- Remove the clip on the right hand side of the glove box (if applicable).
- Pull the glove box loose from the dash. Once it pops free disconnect the electrical connector from the glove box (if applicable).
- Pull the glove box completely free of the dash and set it aside.
- With the filter housing now exposed locate and remove the filter housing door.
- Remove the old filter by pulling it straight out of the housing unit and clean any remaining debris that may be in or around the housing.
- Install new cabin filter into the filter housing.
- Snap the filter housing door back into its original position.
- Slide the clip back on the right hand side of the glove box (if applicable).
- Reposition the glove box back into the dash lining up the screw holes in the glove box with the screw holes in the dash.
- Replace all nine (9) screws.
- Close the glove box.