FRAM Fresh Breeze® Cabin Air Filter
| Height (Inch) | 1.241 |
|---|---|
| Width (Inch) | 7.289 |
| Length (Inch) | 8.195 |
Search
- Description
FRAM® Fresh Breeze cabin air filters can keep up to 98% of road dust and pollen particles from entering a vehicle. The only cabin air filter that uses the natural deodorizing properties of ARM & HAMMER™ baking soda. Contaminants that enter the vehicle with outside air through the vehicle’s air conditioning, heating and ventilation system can become concentrated and expose passengers to road dust, dirt and allergens at higher levels than outside the car.
- Filters up to 98% of dust, pollen and other contaminants
- ARM & HAMMER baking soda combined with carbon embedded in the filter assists in cleaning outside air flowing through the vehicle’s ventilation system
- Helps protect your vehicle's heating and air conditioning unit while also keeping it working efficiently
- Installs on average in 15 minutes
1. Road dust and pollen particles ranging in size from 5-100 microns.
2. Deodorizing tests used isovaleric acid (sweaty odors), geosmin (earthy odors) and dog hairs.
3. ARM & HAMMER, the ARM & HAMMER logo and distinct orange trade dress are trademarks of Church & Dwight Co., Inc. and used under license by FRAM Group IP LLC.
* Always follow OE recommended change intervals.
- Applications
This Item Fits the Following Vehicles:
Year Make Model Engine 2005 SAAB 9-2X H4-2.0L 06-05 SAAB 9-2X H4-2.5L 05-02 SUBARU IMPREZA H4-2.0L 07-02 SUBARU IMPREZA H4-2.5L - Comparison
COMPETITOR NAME COMPETITOR PART # Bosch P3925WS Champ CAF1824P Champion CCF1824 FVP F4485 Hastings AFC1371 Kleener CAF1824P Kleener FCAF1824P LUBER-FINER CAF1824P LUBER-FINER CAF1824C MicroGard 3689 MicroGard 3695 Micronair SB02999 Power Train 3689 Premium Guard PC4485 Promotive C25855P Pronto PC-4485 Purolator C25855 STP CAF1824P Subaru 63210-FE100 Wix 24485 - Installation
TOOLS: #2 Stubby Phillips-head Screwdriver.
LOCATION OF CABIN FILTER: On the passenger side of the vehicle behind the glove box.
NOTE: If vehicle is equipped with a cabin filter a caution label will be located on the left hand side door pillar below the vehicle label.
REMOVE ALL DEBRIS IN AND AROUND FILTER LOCATION.
- While sitting in the passenger seat open the glove box and remove the seven screws which secure the glove box to the dash (three upper screws two lower screws and two screws located in the center).
- Remove the clip on the right hand side of the glove box.
- Pull the glove box loose from the dash. Once it pops free disconnect the electrical connector from the glove box (if applicable). 4. Pull the glove box completely free of the dash and set it aside.
- With the filter housing now exposed locate and remove the filter housing door.
- Remove the old filter by pulling it straight out of the housing unit and clean any remaining debris that may be in or around the housing.
- Install new filter into the filter housing.
- Snap the filter housing door back into its original position.
- Slide the clip back on the right hand side of the glove box.
- Reposition the glove box back into the dash lining up the screw holes in the glove box with the screw holes in the dash.
- Replace all seven screws.
- Close glove box.