FRAM FORCE™ oil filter is engineered to provide advanced protection for all drivers that experience extreme driving conditions. Coated with a rough non-slip textured surface, Total Grip™ allows for easy install and removal. The silicone anti-drain back valve ensures safe engine startups, extending the life of the oil filter. Its synthetic blend media provides 99%+ filtering efficiency and protects up to 15,000 miles (24,000 kilometers).
Proven protection for up to 15,000 miles (24,000 kilometers)
Engineered for tough driving conditions, stop and go traffic, and hot and cold temperatures
Total Grip™ textured surface for easy install and removal
Synthetic blend media provides 99% dirt holding capacitys
Silicone anti-drain back valve helps ensure safe engine start up
*FRAM Group testing of average filter efficiency of FF8A, FF3387A and FF4967 under ISO 4548-12 for particles greater than 20 microns.
**Greater than 3X the functional life of Nitrile ADB when tested per SAE HS806 hot oil and Anti-drain-back test.
Remove drain plug from housing cap if present and allow oil to drain from cap. Remove housing cap old gaskets/O-Rings and filter element. Discard the used filter element and gaskets/O-Rings in the proper manner.
Clean filter housing components and apply a light coating of clean engine oil to the new provided gaskets/O-Rings. Install being careful to avoid damage to the gaskets/O-Rings. Avoid twisting of the gaskets/O-Rings.
Install new filter element into the housing cap. Reinstall the housing cap and tighten to the proper installation torque as listed on the housing cap or in the service manual. Reinstall the housing cap drain if present to the proper installation torque.