FRAM Extra Guard® Oil Filter
| Height (Inch) | 3.984 |
|---|---|
| Outside Diameter (Inch) | 3.656 |
| Anti-Drain Back Valve | Yes |
| Bypass Relief Valve | Yes |
| Gasket Inside Diameter (Inch) | 3.110 |
| Gasket Outside Diameter (Inch) | 3.440 |
| Gasket Thickness (Inch) | 0.225 |
| Gasket Type | Base |
| Attachment Type | Spin-On |
| Burst Pressure (Pounds per Square Inch) | 230.000 |
| Bypass Relief Valve Setting (Pounds per Square Inch) | 12 |
| Filter Media Material | Cellulose/Synthetic Blend |
| Inlet Type | Threaded |
| Inside Thread Diameter (Millimeter) | M22x1.5 |
| Thread Size | Metric |
| Torque Nut | No |
Search
- Description
FRAM Extra Guard® oil filters deliver advanced engine protection for everyday drivers who perform routine oil changes at OE (original equipment) recommended intervals. Equipped with SureGrip® technology, FRAM Extra Guard® oil filters provide a non-slip surface allowing for easy install and removal. The silicone anti-drain back valve ensures safe engine startups, extending the life of the oil filter for up to 10,000 miles (16,000 kilometers).
- Proven protection for up to 10,000 miles (16,000 kilometers)
- Engineered for use with synthetic or conventional motor oils
- SureGrip® technology for easy install and removal
- Filter media is a blend of fiber and resin that captures 95% of the dirt particles
- Silicone anti-drain back valve helps ensure safe engine start up
*FRAM Group testing of average filter efficiency of PH8A, PH3387A and PH4967 under ISO 4548-12 for particles greater than 20 microns.
**Greater than 3X the functional life of Nitrile ADB when tested per SAE HS806 hot oil and Anti-drain-back test.
?Not all features are available on every part number in the product line. Check the package for specific features of individual filters.
- Applications
This Item Fits the Following Vehicles:
Year Make Model Engine - Comparison
COMPETITOR NAME COMPETITOR PART # ACDelco PF1250F Carquest 85372MP Group 7 V4651BP Hastings LF110 NAPA 1372MP NAPA ProSelect Filters 27899MP Parts Master 61372BP Silverline 21372MP Wix 51372MP - Installation
- Use proper protective gear. Used motor oil should not come in contact with bare skin. Engine oil may be hot.
- Place a drain pan under the oil filter and unscrew oil filter.
- Clean mounting base making sure the O-ring from the old filter is not stuck to the filter mount.
- Apply film of clean oil to filter gasket. Do not use grease.
- Screw new filter on until gasket reaches base contact. Then tighten according to instructions on filter using tightening guide markers.
- Check owner’s manual for correct oil specification viscosity and amount.
- Add oil to “full” on dipstick. Idle engine for 5 minutes and check for leaks.
- Shut off engine and recheck oil level after 5 minutes and top off as necessary.