FRAM Synthetic Endurance™ Oil Filter
Search
- Description
FRAM Synthetic Endurance™ premium oil filters are designed to provide extended durability and performance. Its fully synthetic filtration media delivers 99% filtration efficiency and maximum engine protection for up to 25,000 miles (40,000 kilometer)when paired with the appropriate synthetic or high-mileage motor oil. FRAM Synthetic Endurance™ was specially developed for use in modern vehicles and features heavier steel construction for today's higher flow engines.
- Provides maximum protection and performance for up to 25,000 miles (40,000 kilometer).
- Optimized for use with synthetic or high mileage oil.
- Heavy-duty shell and wire screen back synthetic filter media provides maximum durability.
- Designed with a fully synthetic filter media for 99% filtration efficiency.
- 360° Textured Grip provides non-slip surface for easier installation and removal.
- Perfect Seal® No-Stick Gasket provides extended durability.
1 Provides up to 25,000 miles/40,000 km of protection when used with an appropriate synthetic oil. Follow recommended change intervals as outlined in your owner’s manual.
*FRAM Group testing of average filter efficiency of FE8A, FE3387A and FE4967 or equivalent FRAM TG or EG models under ISO 4548-12 for particles greater than 20 microns.
**FRAM Group mulitpass testing of representative sampling of average filter capacity of comparable competitive retail products based on ISO4548-12 for FE8A and FE3387A.
***Greater than 3X the functional life of Nitrile ADB when tested per SAE HS806 hot oil and Anti-drain-back test.
+ FRAM Group testing per USCAR-36 Low Temperature Leakage test after hot oil, when compared to standard nitrile gasket.
ꝉ Not all features are available on every part number in the product line. Check the package for specific features of individual filters.
- Applications
This Item Fits the Following Vehicles:
Year Make Model Engine - Comparison
COMPETITOR NAME COMPETITOR PART # - Installation
- Use proper protective gear. Used motor oil should not come in contact with bare skin. Engine oil may be hot.
- Place a drain pan under the oil filter and unscrew oil filter.
- Clean mounting base making sure the O-ring from the old filter is not stuck to the filter mount.
- Apply film of clean oil to filter gasket. Do not use grease.
- Screw new filter on until gasket reaches base contact. Then tighten according to instructions on filter using tightening guide markers.
- Check owner’s manual for correct oil specification viscosity and amount.
- Add oil to “full” on dipstick. Idle engine for 5 minutes and check for leaks.
- Shut off engine and recheck oil level after 5 minutes and top off as necessary.