FRAM EXTRA GUARD®
OIL FILTER

  • Engineered for Conventional Motor Oil
  • Cellulose and Glass blended media provides protection for oil change intervals up to 5,000 miles1
  • 95% filtration efficiency2
<strong>FRAM</strong><p>This Site requires Flash and Javascript to be enabled. Please check your settings and try again.</p>

INSTALLATION INSTRUCTIONS

  1. Use proper protective gear. Used motor oil should not come in contact with bare skin. Engine oil may be hot.
  2. Place a drain pan under the oil filter and unscrew oil filter.
  3. Clean mounting base making sure the "O" ring from the old filter is not stuck to the filter mount.
  4. Apply film of clean oil to filter gasket. Do not use grease.
  5. Screw new filter on until gasket reaches base contact. Then tighten according to instructions on filter using tightening guide markers.
  6. Check owner's manual for correct oil specification, viscosity and amount.
  7. Add oil to "full" on dipstick. Idle engine for five minutes and check for leaks.
  8. Shut off engine and recheck oil level after 5 minutes and top off as necessary.
FRAM EXTRA GUARD OIL FILTER
OR

UPGRADE TO

Tough Guard

Synthetic-Blend filter media technology provides up to 10,000 miles of protection between oil changes

Learn More
Ctalog Search