VIDEOS DE INSTALACIÓN

Considera esto como un curso intensivo de filtros.

Despues disfruta la satisfacción de saber que realizazste un buen trabajo.

Product Image Product Image

OIL FILTERS

  1. Use proper protective gear. Used motor oil should not come in contact with bare skin. Engine oil may be hot.
  2. Place a drain pan under the oil filter and unscrew oil filter.
  3. Clean mounting base making sure the "O" ring from the old filter is not stuck to the filter mount.
  4. Apply film of clean oil to filter gasket. Do not use grease.
  5. Screw new filter on until gasket reaches base contact. Then tighten according to instructions on filter using tightening guide markers.
  6. Check owner's manual for correct oil specification, viscosity and amount.
  7. Add oil to "full" on dipstick. Idle engine for five minutes and check for leaks.
  8. Shut off engine and recheck oil level after 5 minutes and top off as necessary.

AIR FILTERS

  1. Use proper protective gear.
  2. Loosen wing nut or other fasteners to remove filter cover.
  3. Remove old air filter.
  4. Clean filter cover and housing using a shop vacuum.
  5. Install new air filter. Be sure it is sealed around the perimeter.
  6. Replace cover and fasten.

FRESHBREEZE CABIN AIR FILTERS

Find vehicle-specific FRAM Fresh Breeze model numbers, how-to installation videos and step-by-step instructions here.

Oil Filter Anatomy

- 2011 FRAM Challenge Video 1

FRAM Oil Filter change

on a GM Ecotec

FRAM Oil Filter change

on a Mazda 2.3

FRAM Oil Filter change

on a Hyundai/Kia V6

Filtration and Engineering Testing

- 2011 FRAM Challenge Video 2